Make a route for drainage, protect the structure, and use water-tolerant materials to rebuild
It is pretty much a fact of life that some places are prone to flooding. It is also pretty much a fact of life that flood water is quite dirty.
That dirt, muck, and biological waste absorbs into your walls and floor coverings which can pollute the indoor air even after they have dried out.
In a perfect world—like animation land—step 1 of flood clean up is to get a dumpster. In the real world, you may have to pile it in the front yard.
Step by step:
- Remove the interior trim and wallboard. Chances are, the sheathing was soaked with dirty water, so that will need to be removed, too.
- With the brick exposed, turn your attention to cleaning up the drainage path for future water events. There are usually large blobs of mortar that not only bridge the gap behind the brick but can also fall down and block the escape route for water.
- Chisel excess mortar away from the framing and suck it out of the cavity with a shop vac.
- Now that there is a clear path for water to drain down, give it a place to drain out. Cut out the mortar joints between every third brick along the bottom course and insert a weep screen that will keep insects out while letting water escape.
- With the base of the wall able to expel water, and the cavity behind it clear for drainage, we are ready to flash the bottom of the wall.
- The best way to protect the wall from future flood damage is with a waterproof membrane. Paint over the bottom plate, up the studs a little bit, and down the front of the slab to form a pan that will direct water out of the weep holes we cut earlier.
- Drainage mesh with a facing or filter fabric is installed against the brick. This allows rainwater getting past the brick to drain out of the cavity.
- From there, closed-cell spray foam can be installed in the cavity. Closed cell, 2-pound density polyurethane spray foam will not absorb the water from the next flood, so it will not need to be replaced next time. This adds thermal resistance, water resistance, and structural integrity to the wall.
One last step before closing it up is to paint the framing with latex acrylic paint. Cover it with non-paper faced drywall and with any luck, the next flood repair will be much less invasive.
—This animation was developed with Dr. Joe Lstiburek, P. Eng. of Building Science Corporation according to a recent ASHRAE Fundamentals article, which you can see at buildingscience.com